Skip to main content

Basic:bit(EF02053)

Introduction​

Basic:bit is a basic breakout board of micro:bit. It carries a buzzer and three groups of GVS pins(P0/P1/P2) on board. Each group of GVS pins separately leads out the IO port, 3V port and GND port on micro:bit. Small size with simple structure, it is quite enough for you to complete 98% micro:bit projects.

Features​

  • Small size with smart design, it is a perfect match for your micro:bit.
  • Easily connected to micro:bit and lead out its power and IO ports with screws only.
  • Lead out P0,P1,P2,3V,GND port on micro:bit board.
  • Allow you to complete 98% micro:bit projects with three IO ports.
  • The switch on board controls the ON/OFF status of buzzer.

Parameter​

  • Voltage: 3.3V （Powered by micro:bit）
  • IO Ports: 3
  • Dimension: 51.7mm x 29.1 mm

Packing List​

  • 1 x basic:bit
  • 7 x screws（5 is enough）

Case Study​

Material Needed:​

  • 1 x micro:bit
  • 1 x basic:bit
  • 1 x Octopus LED Module
  • 1 x USB Cable
  • 1 x GVS wire（Or Jumper Wire)

Assembly​

Fix your basic:bit onto micro:bit with screws and nuts. Connect Octopus LED module to P1 port on your basic:bit. Then slide the switch to the speaker end.

Example Code​

You can see the whole program via the link below: https://makecode.microbit.org/_AvW79jCcU2XA

Or you can download the program directly from the page below:

Final Effect​

After saving the above code into micro:bit, the buzzer starts to play the music again and again. At the same time, Octopus LED module twinkles with 1 second space.

Documents​